1. Home
  2. > Blog
  3. >  Analysis Of Equipment Failure Of Production Line In Gravel Yard

Analysis Of Equipment Failure Of Production Line In Gravel Yard

Last Update:2020-05-05 23:53:21

There are many kinds of equipment in the gravel yard with simple structure and strong crushing capacity, which are widely used in crushing operations in various industries. Due to the poor working environment of the equipment and human factors, when the equipment is working in the gravel yard, there will be some common failures, which will affect the production of entrepreneurs. As operators, they need to understand the common faults and solutions of the production line in the gravel yard. The following is the introduction of relevant contents.

First of all, it is necessary to understand the artificial faults of the crusher in the production line of the gravel yard. After a long period of work, the operators did not check the cone crusher regularly according to the requirements, resulting in serious wear of the upper sleeve of the moving cone of the equipment, resulting in the copper chips falling off the inner wall, blocking the oil passage of the tile, resulting in strong vibration during the operation of the cone crusher. In addition, the fixed cone of the equipment in the gravel yard cannot be taken out, thus affecting the normal use and replacement of the fixed cone liner and the normal operation of the crusher.

Secondly, we should be familiar with the cause of the fault caused by artificial. The main reason for the inner wall wear of the dynamic cone bush is that the operator did not check it regularly and did not find the wear degree of the inner wall of the Bush in time, which led to the impact of the equipment in the gravel field on the outer wall of the counterweight, the loosening and falling off of the auxiliary cover and the fixed screws of the counterweight, so the dynamic cone could not operate normally. The ball bearing directly wears the moving cone sleeve, which results in the vibration of the crusher in the production line of the gravel yard.

The human factor that causes the cone and adjusting ring not to rotate and take out is the operator's neglect of inspection. After a long time of operation, the cone crusher in the gravel yard has a relatively large wear degree of the fixed cone liner, which leads to the failure of the iron Chen to remove the relatively large cast steel block iron. At this time, the operator did not check it out. These relatively large cast steel block iron directly enter the equipment in the gravel yard. At this time, the over-iron protection device can not play its due role, thus causing the fixed cone Results that cannot be taken out.

Artificial mechanical failure is an important factor affecting the normal operation of the equipment in the gravel pit, which is mostly caused by the carelessness of the operators. As an important crushing equipment in the production line of the gravel yard, the cone crusher can't work normally once it breaks down, which affects the whole production line, and the loss to the entrepreneurs can't be estimated. Therefore, the operators must pay attention to ensure the safe and orderly operation of the equipment.

NEED A QUESTIONS?

If you are interested in our products, or have any questions for us, you can click the button below

Contact Us